FLUKE PM3082 PDF

I found from a dismantled lab sell a Fluke PM I never heard anything about Fluke analog scopes. plus the name looks like a Philips. Find great deals for Fluke PM Analog Oscilloscope. FLUKE PM , PM , PM, PM ANALOG OSCILLOSCOPE SERVICE MANUAL. Find great deals for Fluke PM Oscilloscope 4 Channels mhz No Cable. Shop with confidence on eBay!.

Author: Samugal Malarn
Country: Colombia
Language: English (Spanish)
Genre: Medical
Published (Last): 17 January 2004
Pages: 148
PDF File Size: 1.39 Mb
ePub File Size: 6.28 Mb
ISBN: 544-7-87583-299-8
Downloads: 19623
Price: Free* [*Free Regsitration Required]
Uploader: Malkree

Page Verify that the jitter of the DTB is not more than 0. Main Time Base Description.

Fluke PM3084 Analog Oscilloscope

Page The linearity of the vertical amplifier is checked by moving a signal with a fixed amplitude vertically over the entire screen area. Error Calibration step Input Control signal Output When ready, the oscilloscope is fine tuned to optimal accuracy. Verify that a horizontal line of 4.

The output signals are measured on the X-deflection plates of the CRT. This takes approximately one minute. At 10 MHz; input to deselected channel equivalent to 8 div.

Fluke PM3082 Oscilloscope 4 Channels 100mhz No Cable

Apparatus should be properly grounded through the protective ground conductor of the power cord. Configuration of mmicroprocessor control part Within 2 minutes the instrument automatically does its main calibrations. The driver transistors are V and V On the power supply there are many parts that carry dangerous high voltages.

  AGUSTIN ANFOSSI ALGEBRA PDF

The maximum allowed jitter is checked in this test. Page bcc U p BCC: The IEEE connector is located at the rear panel of the oscilloscope.

FLUKE PM SERVICE MANUAL Pdf Download.

All circuit boards removed from the instrument must be adequately protected against damage, and all normal precautions regarding the use of tools must be observed. Signal Delay Note 3: Flukf described in this manual is to be done only by qualified service personnel. To reduce the rise of electric shock donot perform any servicing other than that contained in the operating Page Probe Adjust signal is distortion-free and has equal intensity. The trigger sensitivity depends on the amplitude and frequency of the trigger signal.

Apply a 50 Hz sine wave signal of 8 V pp to input CH1; After having opened the instrument, the voltage can be measured with a voltmeter or oscilloscope. Every attenuator basically consists of four sections. It is also possible that the rotor makes no contact. Before soldering, bend the wires through the holes of the solder leads, or wrap the wires around the leads in the form of an lfuke U, or, maintain wiring ridigity by cable clamps or cable lacing.

  AASTRA 2380IP PDF

pmm3082

Fluke PM Analog Oscilloscope | eBay

Its function is identical to that of the other amplifier half. Adjust the input signal to an amplitude of exactly 6 divisions. Pull the two self-locking white plastic clamps. To print the manual completely, please, download it. Page Page – Horizontal deflection; X deflection coef Printed circuit board lay-out of Y-out unit If not present install 2 penlight LR6 back up batteries in the holder at the rear panel of the oscilloscope. The capacitor C determines the cut-off frequency if the bandwidth limiter is active.

Before turning on the instrument, ensure that it has been installed in accordance with the Installation Instructions, outlined in Section 2 of the Operation Guide.